Hoover S3755050 Bedienungsanleitung PDF herunterladen (Seite 7)

Exhaust filter

How to clean

Turn cleaner off and disconnect from

electrical outlet.

The exhaust filter, located behind the

grill on the body of the cleaner, is wash-

able. To clean, rotate grill (F) counter-

clockwise. Remove the exhaust filter (G).

Wash filter by running it under cold tap

water. Do not use soap or detergent.

Do

not use the small brush to clean this

filter, as brushing will damage the

effectiveness of the filter. Allow to dry

thoroughly before replacing on cleaner.

The exhaust filter should be cleaned at

least once a year. The filter may become

discolored with use, but the filtration effi-

ciency will not be affected.

Washing the dirt cup

Turn cleaner off and disconnect from

electrical outlet.

Remove the dirt cup by pressing the but-

ton on the top of the cleaner and pulling

the cup straight out. Remove lid. The

cup may be rinsed by running it under

cold tap water and dried with a soft

cloth. Do not replace dirt cup on cleaner

unless it has been dried thoroughly.

Should the dirt cup platform flaps (C)

become dislodged, refit using the dia-

gram on the platform.

Grasp the filter and rotate counter-clock-

wise. Clean the filter using the small

brush located under the tool lid.

If desired, the filter may be rinsed by

running it under cold tap water.

Do not

use soap or detergent. Shake excess

water from filter and allow to dry thor-

oughly before replacing it in cleaner.

Replace the filter by lining up tabs on fil-

ter with grooves on lid and rotating

clockwise.

If the red light is still on after the filter

has been cleaned, there may be a

blockage in the hose or wands. Refer to

“If you have a problem” section.

Cleaning the filter

The dirt cup filter (D) is located under

the dirt cup lid.

When the filter needs to be cleaned, the

red light (E) will come on.

7

3-3

3-4

3-5

3-6

C

C

D

E

G

F

Continued

➟

Belt replacement

The belt in your power nozzle drives the

agitator. It has been designed specifical-

ly for use in this cleaner and is important

for effective operation.

What to buy

There are other belts manufactured that

are similar in shape and size, but are not

designed for the HOOVER power nozzle.

Such belts do not operate the agitator cor-

rectly and may create stress which could

damage your power nozzle. Use only a

genuine HOOVER Belt

part no.

40201180 when a belt replacement is

necessary.

When to replace

The belt should be checked from time to

time to be sure it is in good condition. To

check, remove the nozzle cover (see fol-

lowing section). Replace the belt if it is

stretched, cut, or broken.

How to replace

Disconnect cleaner from electrical

outlet and disconnect power nozzle

from extension wands.

To remove hood, turn nozzle over and

unscrew the 4 recessed Phillips head

screws.

Note: Do not remove the 3 screws in

the triangle formation as these hold

the motor in place.

3-7

1 2 3 4 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare